台湾标准电机SEW仪器仪表--PD-20S Probe High Voltage Testers

    
 
PD-20S   High Voltage Testers
H.V. Probe  
Input Impedance : 500M Ohm for scope  
PD-20S
FEATURES
 
 PD-20 and PD-28 have the same shape and color but different specifications.
 Meet IEC/EN 61010-1, IEC/EN 61010-2-031
 PD-20 is a high voltage probe that is used with DMM
 PD-20 and PD-28 are high voltage probes. They measure both AC and DC voltages with your multimeter. They consist of 2 kinds of contact tips, a test clip for the ground, a set of test leads for multimeter and a high qualify enclosure. The enclosure has very good insulation properties.
 They are lightweight and ruged. Two kinds of contact tips are avaialble. One is a round needle tip for normal use. Another is a special flat spring type for CRT anode.
 Before taking any measurements, first connect the alligator clip of this probe to earth ground and amke sure connection is proper.
 PD-20S for scope.
SPECIFICATIONS
 
Input Impedance 500M Ohm.
Attenuation Ratio 1000 : 1
Accuracy DCV (0 ~ 20kV) +/- 1%, DCV (20kV ~ 30kV) +/- 2%, ACV (0 ~ 20 kV) typically +/- 5% at 60Hz
Max. Working Voltage 30kV DC or 20kV AC
Operating Temperature 0 degree C ~ 50 degree C
Storage Temperature -10 degree C ~ 60 degree C
Cable Length 1m
Weight Approx. 260g
特 點

● 必須配合數位式三用電表使用。
● 可量測交流電壓與直流電壓。
● 適用頻率:50Hz/60Hz。
● 材質輕巧、耐壓絕緣度良好。
● 符合IEC/EN 61010-1 IEC/EN 61010-2-031

(供示波器使用)

規 格

內 阻 500 M
衰減比例 1000 : 1
量測範圍及準確度 直流電壓(DCV):0-20kV:±1%
20kV-30kV:±2%
交流電壓(ACV):0-20kV:±5%
操作溫度 0°C ~ 40°C
接地線長度 1公尺
重 量 約260g